Written by:Apple Rubber
Category:Case Studies
Case Study: Phenyl Silicone Seal for Extreme Low Temperature
Recently, one of our customers contacted us about a problem she was having with an O-Ring that…
Read MoreCase Studies
Written by:Romel Ner
Category:Case Studies
5 Reasons Design Engineers Should Start at AppleRubber.com
Design engineers want to partner with suppliers who can support product development and meet…
Read More
Written by:Stephen Wozniak
Category:Case Studies
How to Measure Surface Finish of Rubber Parts with 3D Models:…
We previously showed how to measure surface finish of rubber parts with the nSpec3D®. This…
Read More
Written by:Joe Divissich
Category:Case Studies
Understanding Tolerance Stack-Up in MicrOrings
Today’s smaller designs can present some big challenges for engineers, particularly the…
Read More
Written by:Stephen Wozniak
Category:Case Studies
How To Measure Surface Finish of Rubber Parts with 3D Models
When it comes to prototyping, surface finish is critical since it can affect the accuracy, cost…
Read More
Written by:Nathan Enser
Category:Case Studies
How to Avoid Seal Failure in Low-temperature Environments
Low temperatures raise big concerns for rubber manufacturers. Applications in major industries…
Read More
Written by:Dave Meehan
Category:Case Studies
Measuring cooked spaghetti: Rubber part geometry measurement
The very properties that make rubber a good choice for seals also make it very difficult to…
Read More
Written by:Dave Meehan
Category:Case Studies
Investigating the compression set of rubber compounds
Rubber compounds permanently deform under strain. This permanent deformation is of particular…
Read More